Touch Controller - Cisco EX Series Getting Started Manual

Cisco TelePresence Video Systems
Contents
Configuration using the Touch controller
Waking up the system
If no menu is displayed on the Touch controller, tap the display
to wake up the system.
If the system does not wake up:
• Make sure the Touch controller is connected to the main unit.
• Make sure the main unit is connected to power and
switched on.
If the system has just been switched on, wait a few minutes to
allow the system to start up.
If in doubt, read the installation guide for your product.
Back to task overview
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Introduction User interfaces Configuration Configuration

Touch controller

12
Getting Started Guide
Appendices Contacts
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.