Video Input Connector [1..5] Optimaldefinition Threshold60Fps - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction
Video Input Connector [1..5] OptimalDefinition Profile
This setting will only take effect if the corresponding Video Input Connector [n] Quality
setting is set to Motion.
The optimal definition profile reflects the lighting conditions in the video conferencing room
and the quality of the camera. The better lighting conditions and the better quality of the
camera, the higher the profile. Generally, the Normal or Medium profiles are recommended.
However, when the lighting conditions are very good, the High profile can be set in order to
increase the resolution for a given call rate. The resolution must be supported by both the
calling and called systems.
Use the Video Input Connector [n] OptimalDefinition Threshold60fps setting to set the
lowest resolution where 60 fps is allowed. Below this threshold 30 fps is the manximum
frame rate.
Requires user role: ADMIN, INTEGRATOR
Default value: Medium
Value space: Normal/Medium/High
Normal: Use this profile for a normally to poorly lit environment. Resolutions will be set
rather conservative.
Medium: Requires good and stable lighting conditions and a good quality video input. For
some call rates this leads to higher resolution.
High: Requires nearly optimal video conferencing lighting conditions and a good quality
video input in order to achieve a good overall experience. Rather high resolutions will be
used.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Maintenance

Video Input Connector [1..5] OptimalDefinition Threshold60fps

For each video input, this setting tells the system the lowest resolution where it can transmit
60 fps. So for all resolutions lower than this, the maximum transmitted frame rate would be
30 fps, while above this resolution 60fps would also be possible, if the available bandwidth
is adequate.
Requires user role: ADMIN
Default value: 1280_720
Value space: 512_288/768_448/1024_576/1280_720/1920_1080/Never
512_288: Set the threshold to 512x288.
768_448: Set the threshold to 768x448.
1024_576: Set the threshold to 1024x576.
1280_720: Set the threshold to 1280x720.
1920_1080: Set the threshold to 1920x1080.
Never: Do not set a threshold for transmitting 60fps.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
147
Administrator Guide
System settings System settings Appendices