Connect The Touch 10 Controller - Cisco SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

Connect the Touch 10 controller

Touch 10 must be paired to the video system via the network (LAN).
This is referred to as remote pairing.
Connect Touch 10 to the video system via the
network (LAN)
Connect Touch 10 and the video system to network wall sockets or to
a network switch as illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up procedure begins.
Follow the instructions on screen.
When the Select a room system screen appears, note the following:
• A list of video systems signalling that they are available for paring
will show up on the screen. Tap the name of the video system you
want to pair with.
Note that the following must be fulfilled for a video system to show
up in the list:
• The video system and Touch 10 must be on the same subnet.
• The video system must have been restarted within the last 10
minutes. If the video system does not appear in the list, try
restarting it.
• If the video system does not appear in the list of available systems,
enter its IP address or hostname in the input field. Tap Connect.
• You have to log in with username and passphrase for the paring
process to commence. Tap Login.
A user with the USER role is sufficient; you do not need the ADMIN
role to perform this task.
Read more about how to create a user account and assign a role
to it in the ► User administration chapter.
If Touch 10 needs software upgrade, new software will be downloaded
from the video system and installed on the unit automatically as part of
the set-up procedure. Touch 10 restarts after the upgrade.
D15330.06 SX10 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Peripherals
(page 1 of 2)
Power
• 100-240 VAC
• 50/60 Hz
Maintenance
SWITCH
PoE
injector
AP
Contact information
The video system's
name or address is
displayed in the status
bar when Touch 10 is
successfully paired to
the video system.
The Ethernet connector
is behind the lid at the
rear of Touch 10.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
43
Administrator Guide
System settings Appendices
Standard Ethernet cable
2
Network (LAN)
Standard Ethernet cable
Network (LAN)
PoE rated Ethernet cable
If the network infrastructure provides
1
Power over Ethernet (PoE), you do not
need a PoE injector; Touch 10 should
be connected directly to the wall socket
(Ethernet switch) with a PoE rated
Ethernet cable.
For safety, the PoE source must be in
the same building as Touch 10. The PoE
rated Ethernet cable can be up to 100 m
(330 ft).
2 SX10 can also be powered over Ethernet
if the network infrastructure supports
PoE. If so, you must use a PoE rated
cable.
1