Conference Presentation Onplacedonhold; Conference Presentation Relayquality; Conference Videobandwidth Mode - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Conference Presentation RelayQuality

This configuration applies to video systems that are using the built-in MultiSite feature
(optional) to host a multipoint video conference. When a remote user shares a presentation,
the video system will transcode the presentation and send it to the other participants in the
multipoint conference. The RelayQuality setting specifies whether to give priority to high
frame rate or to high resolution for the presentation source.
Requires user role: ADMIN
Default value: Sharpness
Value space: Motion/Sharpness
Motion: Gives the highest possible frame rate. Used when there is a need for higher
frame rates, typically when there is a lot of motion in the picture.
Sharpness: Gives the highest possible resolution. Used when you want the highest
quality of detailed images and graphics.

Conference Presentation OnPlacedOnHold

Define whether or not to continue sharing a presentation after the remote site has put you
on hold.
Requires user role: ADMIN
Default value: NoAction
Value space: Stop/NoAction
Stop: The video system stops the presentation sharing when the remote site puts you on
hold. The presentation will not continue when the call is resumed.
NoAction: The video system will not stop the presentation sharing when put on hold. The
presentation will not be shared while you are on hold, but it will continue automatically
when the call is resumed.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Maintenance

Conference VideoBandwidth Mode

Define the conference video bandwidth mode.
Requires user role: ADMIN
Default value: Dynamic
Value space: Dynamic/Static
Dynamic: The available transmit bandwidth for the video channels are distributed among
the currently active channels. If there is no presentation, the main video channels will
use the bandwidth of the presentation channel.
Static: The available transmit bandwidth is assigned to each video channel, even if it is
not active.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
100
Administrator Guide
System settings System settings Appendices