Cisco TelePresence SX80 Administrator's Manual page 53

Cisco TelePresence SX80

Introduction
Set up the PresenterTrack feature
Diagnostics mode
In order to troubleshoot you can set the video system in
PresenterTrack diagnostics mode.
• Sign in to the xAPI and run the following command.
xCommand Cameras PresenterTrack Set Mode: Diagnostic
In diagnostics mode the video system screen shows the stage
area (the zoomed out overview image), and the indicators:
RED: The trigger zone.
YELLOW: The cropped image that shows a zoomed in view of
the presenter.
GREEN: A face is detected and it is tracked.
GREEN BLINKING, FILLED: Indicates a positive face detection.
If the tracked individual does not get a valid face-read the
square will become red.
RED BLINKING, FILLED: Indicates a false face detection. After
some seconds the tracking will stop.
BLUE: A face is detected but the face is not tracked.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Peripherals
(page 5 of 5)
The red rectangle is
the trigger zone.
Maintenance
The green square
indicates the at face is
tracked.
The yellow rectangle is the cropped
image that follows the presenter. The
yellow rectangle is not visible until a
person steps into the trigger zone and is
being tracked.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
53
Administrator Guide
System settings Appendices
The blue square indicates
the at face is detected but
not tracked.