Cisco TelePresence SX80 Administrator's Manual page 59

Cisco TelePresence SX80

Introduction
Connect the Touch 10 controller
Connect Touch 10 to the video system
via the network (LAN)
Connect Touch 10 and the video system to network wall
sockets or to a network switch as illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up
procedure begins. Follow the instructions on screen.
When the Select a room system screen appears, note the
following:
• A list of video systems signalling that they are available
for paring will show up on the screen. Tap the name of
the video system you want to pair with.
Note that the following must be fulfilled for a video
system to show up in the list:
• The video system and Touch 10 must be on the
same subnet.
• The video system must have been restarted within
the last 10 minutes. If the video system does not
appear in the list, try restarting it.
• If the video system does not appear in the list of
available systems, enter its IP address or hostname in
the input field. Tap Connect.
• You have to log in with username and passphrase for
the paring process to commence. Tap Login.
A user with the USER role is sufficient; you do not need
the ADMIN role to perform this task.
Read more about how to create a user account and
assign a role to it in the ► User administration
If Touch 10 needs software upgrade, new software will
be downloaded from the video system and installed on
the unit automatically as part of the set-up procedure.
Touch 10 restarts after the upgrade.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Peripherals
(page 2 of 3)
Power
• 100-240 VAC
• 50/60 Hz
Contact information
The video system's
name or address is
displayed in the status
chapter.
bar when Touch 10 is
successfully paired to
the video system.
Maintenance
SWITCH
PoE
injector
AP
The Ethernet connector
is behind the lid at the
rear of Touch 10.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
59
Administrator Guide
System settings Appendices
Standard Ethernet cable
Standard Ethernet cable
PoE rated Ethernet cable
If the network infrastructure provides
1
Power over Ethernet (PoE), you do not
need a PoE injector; Touch 10 should
be connected directly to the wall socket
(Ethernet switch) with a PoE rated
Ethernet cable.
For safety, the PoE source must be in
the same building as Touch 10. The PoE
rated Ethernet cable can be up to 100 m
(330 ft).
Network (LAN)
Network (LAN)
1