Power On And Off - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction Introduction

Power On and Off

Power On/Off with the Power switch or Shutdown button
The power switch on the codec's rear side is its main
On/Off switch.
It may take a few minutes for the codec to start up. The
Power LED lights steadily when the system is ready for
use.
Shutdown You can use the Shutdown button on the front panel to
button switch the codec On and Off, provided that the Power
switch on the codec's rear side is On.
• To switch Off the codec, hold the button until the
LEDs go out.
• To switch On the codec, hold the button until the
LEDs flash. It may take a few minutes for the codec
to start up. The system is ready for use when the
Power LED lights steadily.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Maintenance
Restart and standby using the user
interface
Restart the system
1. Select the settings icon (cogwheel) in the status bar of
2. Select
3. Select
Power
Enter/exit standby mode
switch
1. Select the settings icon (cogwheel) in the status bar of
2. Select Standby.
Power Off or restart the system remotely
Sign in to the web interface and navigate to
Restart.
Restart the system
Click
It takes a few minutes before the system is ready for use.
Power Off the system
Click
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
12
Administrator Guide
System settings Appendices
the user interface.
System Information > Restart.
Restart again to confirm your choice.
the user interface.
Restart device... and confirm your choice.
Shutdown device... and confirm your choice.
You cannot power the system on again remotely.
Maintenance >