Audio Input Hdmi [1..3] Level; Open A Web Browser And Enter The Ip Address Of The Video Audio Input Hdmi [1; Audio Microphonereinforcement Gain; Audio Soundsandalerts Ringtone - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Audio MicrophoneReinforcement Gain

The gain (in dB) that will be applied to the mixed microphone signal that is fed to the
selected MicrophoneReinforcement outputs.
Requires user role: ADMIN, INTEGRATOR
Default value: -54
Value space: Integer (-54..15)
Use this gain to adjust the level of microphone signal that should be fed to the local
output. The value -54 means "Off", and no signal will be fed from the microphone to the
output.

Audio SoundsAndAlerts RingTone

Define which ringtone to use for incoming calls.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: Sunrise
Value space: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/
Calculation/Mellow/Ringer
Select a ringtone from the list.

Audio SoundsAndAlerts RingVolume

Define the ring volume for incoming calls.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: 50
Value space: Integer (0..100)
The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Maintenance

Audio Input HDMI [1..3] Level

Define the audio level of the HDMI input connector.
Requires user role: ADMIN, INTEGRATOR
Default value: 0
Value space: Integer (-24..0)
Select a value between -24 and 0, in steps of 1 dB.
Audio Input HDMI [1..3] Mode
Define if the audio channels on the HDMI input shall be enabled. The HDMI inputs have two
audio channels.
Requires user role: ADMIN, INTEGRATOR
Default value: HDMI [1..2]: Off HDMI [3]: On
Value space: Off/On
Off: Disable audio on the HDMI input.
On: Enable audio on the HDMI input.
Audio Input HDMI [1..3] VideoAssociation MuteOnInactiveVideo
Determine whether to play audio only when you present the HDMI input source, or to always
play audio when an audio source is connected to the HDMI input.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: Audio is always played, locally and to far end; you do not have to present the HDMI
input source.
On: Audio is played, locally and to far end, only when you present the HDMI input source.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
83
Administrator Guide
System settings System settings Appendices