Video Defaultlayoutfamily Remote; Video Defaultmainsource; Video Input Connector [1..5] Cameracontrol Mode - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Video DefaultLayoutFamily Remote

Select which video layout family to be used for the remote participants.
Requires user role: ADMIN
Default value: Auto
Value space: Auto/Equal/Prominent/Overlay/Single
Auto: The default layout family, as given by the local layout database, will be used as the
remote layout.
Equal: The Equal layout family will be used as the remote layout. All videos have equal
size, as long as there is space enough on the screen.
Prominent: The Prominent layout family will be used as the remote layout. The active
speaker, or the presentation if present, will be a large picture, while the other participants
will be small pictures. Transitions between active speakers are voice switched.
Overlay: The Overlay layout family will be used as the remote layout. The active speaker,
or the presentation if present, will be shown in full screen, while the other participants
will be small pictures-in-picture (PiP). Transitions between active speakers are voice
switched.
Single: The active speaker, or the presentation if present, will be shown in full screen.
The other participants are not shown. Transitions between active speakers are voice
switched.

Video DefaultMainSource

Define which video input source shall be used as the main video source.
Requires user role: ADMIN, USER
Default value: 1
Value space: 1/2/3/4
Set the source to be used as the main video source.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Maintenance

Video Input Connector [1..5] CameraControl Mode

Define whether the camera that is connected to this video input connector can be
controlled or not.
Note that camera control is not available for Connector 5 (S-video/Composite).
Requires user role: ADMIN, INTEGRATOR
Default value: Connector 1, 2, 3: On Connector 4, 5: Off
Value space: Connector 1, 2, 3, 4: Off/On Connector 5: Off
Off: Disable camera control.
On: Enable camera control.
Video Input Connector [1..5] CameraControl CameraId
The camera ID is a unique identifier of the cameras that are connected to the video input.
Use the xStatus Camera API command to see the IDs of the different cameras.
Requires user role: ADMIN, INTEGRATOR
Default value: Connector n: n Connector 5: 1
Value space: Connector 1, 2, 3, 4: 1/2/3/4/5/6/7 Connector 5: 1
Select the ID of the camera.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
145
Administrator Guide
System settings System settings Appendices