Zone Name - HP 6127XLG Blade Series Command Reference Manual

Syntax
zone mode enhanced
undo zone mode enhanced
Default
The basic zoning mode is enabled in a VSAN.
Views
VSAN view
Predefined user roles
network-admin
Usage guidelines
Only FCF switches and VSANs operating in FCF mode support this command.
A zoning mode switchover causes a zone distribution to ensure zoning mode consistency across the
fabric. Before enabling the enhanced zoning mode, make sure all switches in the fabric support this
mode.
After you change the zoning mode, the switch distributes the change to the entire fabric. If the distribution
fails, the system prints a log message, and the change takes effect only on the local switch. In this case,
to ensure zoning mode consistency across the fabric, manually trigger a complete distribution.
If the size of the active zone set exceeds the system limit in basic zoning mode, enhanced zoning cannot
be switched to basic zoning.
Examples
# Enable the enhanced zoning mode in VSAN 2.
<Sysname> system-view
[Sysname] vsan 2
[Sysname-vsan2] zone mode enhanced
The zoning database in this switch would be distributed throughout the fabric. Continue?
[Y/N]:y
Related commands
display zone status
•
• zoneset distribute

zone name

Use zone name to create a zone and enter its view. If the zone has been created, the command leads you
to the zone view directly.
Use undo zone name to delete a zone.
Syntax
zone name zone-name
undo zone name zone-name
Views
VSAN view
93