Field
Current speed
OS device name
FC ping commands
fcping
Use fcping to FCping an address.
Syntax
fcping [ -c count | -t timeout ] * fcid fcid vsan vsan-id
Views
Any view
Predefined user roles
network-admin
Parameters
-c count: Specifies the number of echo requests to be sent, in the range of 0 to 2147483647 and
defaulting to 5. The value of 0 indicates that echo requests are continuously sent until you manually stop
sending them.
-t timeout: Specifies the timeout value in seconds of an echo reply. The value range is 1 to 10 and defaults
to 5. If the source does not receive an echo reply within the timeout period, it considers the echo reply
timed out.
fcid fcid: Specifies the destination address.
If the destination is a node, the fcid argument indicates the FC address of the node.
•
If the destination is an FC switch, the fcid argument indicates the domain controller address FFFCxx
•
of the switch, where xx is the domain ID of the destination switch. For example, if the domain ID of
the destination switch is 3, its domain controller address is FFFC03.
vsan vsan-id: Specifies a VSAN by its ID in the range of 1 to 3839.
Usage guidelines
Only FCF and FCF-NPV switches support this command.
Description
The current speed can only be one of the following options:
•
1 Gbps.
•
2 Gbps.
•
4 Gbps.
•
8 Gbps.
•
10 Gbps.
•
16 Gbps.
•
20 Gbps.
•
32 Gbps.
•
40 Gbps.
Unknown is displayed for speeds other than the preceding ones. Speed not
established is displayed when the current speed cannot be determined.
Operating system name of the port.
127