zone merge-control restrict
Use zone merge-control restrict to set the merge control mode to Restrict in a VSAN.
Use undo zone merge-control restrict to restore the default.
Syntax
zone merge-control restrict
undo zone merge-control restrict
Default
The merge control mode is Allow.
Views
VSAN view
Predefined user roles
network-admin
Usage guidelines
Only FCF switches and VSANs operating in FCF mode support this command.
This command is supported only in enhanced zoning mode.
Two merge control modes are available: Restrict and Allow. For more information about the Restrict and
Allow merge control modes, see FCoE Configuration Guide.
In enhanced zoning mode, the merge control mode affects the result of a merge operation. A merge
operation can succeed only when the merge control mode is the same on both participating switches. If
the merge operation fails, the link connecting the participating switches is isolated.
To ensure a consistent merge control mode across the fabric, use the zone activate or zone distribute
command after you configure this command.
Examples
# Set the merge control mode to Restrict for VSAN 2.
<Sysname>system-view
[Sysname] vsan 2
[Sysname-vsan2] zone merge-control restrict
# Set the merge control mode to Allow for VSAN 2.
[Sysname-vsan2] undo zone merge-control restrict
Related commands
•
zone mode enhanced
zoneset activate
•
zoneset distribute
•
zone mode enhanced
Use zone mode enhanced to enable the enhanced zoning mode in a VSAN.
Use undo zone mode enhanced to restore the default.
92