Fc Tracert Commands; Fctracert - HP 6127XLG Blade Series Command Reference Manual

Field
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max =
0.889/0.969/1.281 ms

FC tracert commands

fctracert

Use fctracert to detect bidirectional routing information between the local end and a destination. The
destination can be a node or FC switch.
Syntax
fctracert [ -t timeout ] fcid fcid vsan vsan-id
Views
Any view
Predefined user roles
network-admin
Parameters
-t timeout: Specifies the timeout value in seconds for the entire FC tracert process. The value range for this
argument is 1 to 10. This argument is 5 by default.
fcid fcid: Specifies the destination address.
If the destination is a node, the fcid argument indicates the FC address of the node.
•
If the destination is an FC switch, the fcid argument indicates the domain controller address FFFCxx
•
of the switch, where xx is the domain ID of the destination switch. For example, if the domain ID of
the destination switch is 3, its domain controller address is FFFC03.
vsan vsan-id: Specifies an existing VSAN by its ID in the range of 1 to 3839.
Usage guidelines
Only FCF and FCF-NPV switches support this command.
The bidirectional routing information includes WWNs and domain controller addresses of all switches
on a round trip. The switch supports a maximum of 255 hops for a round trip.
To abort the FC tracert operation during the execution of this command, press Ctrl+C.
Examples
# Detect bidirectional routing information between the local end and a node with FC address 0xd70000
in VSAN 1.
<Sysname> fctracert fcid d70000 vsan 1
Route present for: 0xd70000, press CTRL_C to break.
20:00:00:0b:46:00:02:82(0xfffcd5)
Description
Number of echo requests sent.
Number of echo replies received.
Percentage of packets not responded to the total number of
packets sent.
Minimum/average/maximum response time, in
milliseconds.
129