Vfc Interface Commands; Bandwidth; Bind Interface - HP 6127XLG Blade Series Command Reference Manual

Related commands
display fcoe-mode

VFC interface commands

bandwidth

Use bandwidth to set the expected bandwidth for an interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Default
The expected bandwidth (in kbps) is the interface baud rate divided by 1000.
Views
VFC interface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth determines the cost of the interface, which is used for route calculation.
By default, the baud rate of a VFC interface is 10 Gbps.
Examples
# Set the expected bandwidth to 50 kbps for interface VFC 1.
<Sysname> system-view
[Sysname] interface vfc 1
[Sysname-Vfc1] bandwidth 50

bind interface

Use bind interface to bind a VFC interface to an Ethernet interface. The Ethernet interfaces in this
command refer to Layer 2 Ethernet interfaces, Layer 2 aggregate interfaces, S-channel interfaces, and
S-channel aggregate interfaces.
Use undo bind interface to remove the binding.
Syntax
bind interface interface-type interface-number [ mac mac-address ]
undo bind interface
3