Display Zoneset Active - HP 6127XLG Blade Series Command Reference Manual

Table 30 Command output
Field
fcid
pwwn
Related commands
member (zone set view)
•
• zoneset clone
zoneset name
•
zoneset rename
•

display zoneset active

Use display zoneset active to display information about the active zone set.
Syntax
display zoneset active [ vsan vsan-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vsan vsan-id: Specifies a VSAN by its ID in the range of 1 to 3839. If you do not specify a VSAN, this
command displays information about active zone sets in all VSANs.
Usage guidelines
Only FCF and FCF-NPV switches support this command.
A VSAN can have only one active zone set.
The following rules apply to the command output:
• Zone members are displayed in the order of FC address, pWWN, and fWWN. Zone members
specified by the same identifier are displayed in ascending order of ASCII codes corresponding to
the identifier values.
For a zone member that exists in the local name service database, this command prefixes an
•
asterisk (*) to the related line.
If a zone member is specified by its pWWN, the switch performs the following operations:
−
−
If a zone member is specified by its fWWN, the switch displays FC addresses of all N_Ports that
log in through the F_Port. Each FC address is followed by the fWWN enclosed in brackets ([]).
Description
FC address of a zone member.
pWWN of a zone member.
Queries the associated FC address of the zone member from the name service database
and displays the FC address.
Appends the pWWN enclosed in brackets ([]) to the FC address.
81