Managing The Used Master [Protect]; Setting [Protect]; Canceling [Protect] - Riso 9450 User Manual

Managing the Used Master
[Protect]
After printing, the master that has been made is still
loaded on the print drum (cylinder) in the print ready
status.
When [Confidential] (A 89) is turned on, the master
that has been made is discarded. Therefore, you
can prevent improper printing of confidential docu-
ments.
However, as the discarded masters are accumu-
lated in the master disposal box, there is a risk that
the box could be removed by a third party with mali-
cious intent.
In order to avoid such a risk, this machine features
the [Protect] function.
BWhen [Protect] is set to [ON], the time that
is required for switching to [Auto Sleep]
(A 110) is fixed to one minute.
BWhen [Protect] is set to [ON], you cannot
use [Renew Page]
■ Operation when [Protect] is set to on
• After printing is complete, a confirmation screen that
prompts you to execute [Confidential] is displayed.
[OK]: Touch this button to discard the already made
masters.
[Cancel]: Touch this button if you do not need to dis-
card the master or you want to print further copies.
The confirmation screen is displayed in the following
cases:
– When the [RESET] key is pressed.
– When the time that is set in [Auto Clear]
elapses.
– After restored from sleep mode.
– When the power is turned on.
B[Cancel] is not displayed in the following
cases:
CWhen a new print drum (cylinder) for
which [Confidential] has not been exe-
cuted is installed.
CWhen this machine has been restored
from sleep mode that was activated
while a confirmation screen prompting
you to execute [Confidential] was dis-
played.
(A 72).
(A 110)
Chapter 7 Setting the Operation Conditions
• The master disposal box is locked so that it cannot
be removed. However, you can remove the master
disposal box if a master is jammed in the master dis-
posal section or the master disposal box becomes
full.
BThe master disposal box can be locked
with a padlock, etc., so that it cannot be
removed by anyone except for the adminis-
trator. When locking, insert the padlock into
the lock lever hole as illustrated below.
(Purchase a commercially available pad-
lock. The diameter of the hole for inserting
the padlock is 7 mm [9/32 inches].)

Setting [Protect]

1
Touch [Protect] in the [Admin.]
screen.
[Protect] is set to [ON].

Canceling [Protect]

1
Touch [Protect] in the [Admin.]
screen.
After the message "Please Wait a Moment" is
displayed, [Protect] is set to [OFF].
Lock lever
Padlock
123
7