Riso 9450 User Manual page 153

Code Message
D17 Wrong-type Master
Installed
or Cannot Read
Master Info
Replace Master Roll
or Contact dealer/Riso
Office
■ E00-0000: Maintenance call error
Code Message
E01 !!Low Battery!!
Call Service
E02 !!Maintenance!!
Call Service
■ F00-0000: Warning
B[Cancel] or [Continue] may be displayed on the screen.
To interrupt the operation, touch [Cancel]. Touch [Continue] to resume the operation.
Code Message
F01 No Master on Print Drum
Make a New Master
F02 Page Format is Larger
than Paper Size
!! Possible Ink Smudges on
Prints !!
F04 Reached to the limit count
Contact the administrator
F10 Page Format is Larger
than Paper Size
!! Possible Ink Smudges on
Prints !!
(Continue->PROOF Key)
Action
Check that the type of master roll is appropriate.
Set an appropriate master roll in place.
BUse the master roll that is recommended by RISO. If other
master rolls are used, it may result in malfunctions or
problems.
Check if the [ I ] section of the master core is bent or cut.
The [ I ] section of the master core contains the necessary information
for printing.
Set a master roll in place that contains a [ I ] section that is not bent or
cut.
(A 133 "Setting the Master Roll")
Action
The internal battery of this machine is almost depleted.
Consult your dealer or authorized service representative for battery
replacement.
Consult your dealer or authorized service representative for periodic
inspection.
Action
After touching [Close], perform master making.
BIf you leave the print drum (cylinder) with no master
attached, the print drum (cylinder) will dry, and this situa-
tion may result in malfunctions. Be sure to perform mas-
ter making or [Confidential]
to the print drum (cylinder).
The paper that is currently set is smaller than the size of the master
that has been made.
Check the size of the paper and set an appropriate paper.
The count has reached the upper limit of the preset number of masters
to be created or number of printed copies. Please contact your admin-
istrator.
(A 121 [User Management]-[Setting the upper limit number of copies
that can be used])
The paper that is currently set is smaller than the size of the master
that has been made.
Check the size of the paper and set an appropriate paper.
To continue outputting the proof copies, press the [PROOF] key.
Chapter 11 Troubleshooting
(A 89) and load a master on
151
11