Riso 9450 User Manual page 166

164
Chapter 11 Troubleshooting
Problem
Papers are not smoothly fed
from the paper feed tray.
(Papers are skipped, or mul-
tiple sheets are fed)
The printed card is peeling,
or the leading edge becomes
wrinkled.
Point to check
Check if appropriate papers
are used.
Check if the position of the
paper feed setting lever is
appropriate.
Check if the angle of the
stripper plate is appropriate.
Check if [Paper Feed Adj.] is
set properly.
Check if the angle of the
stripper plate is appropriate.
Action
Use papers that are suitable for this machine.
(A 14 "Printing papers")
When using thick or slippery papers, switch the
paper feed setting lever to the position of [CARD].
(A 28 "Setting up the paper feed tray and the
paper")
Turn the adjustment dial for the stripper plate angle
to adjust the angle of the stripper plate in accor-
dance with the paper conditions.
BBefore the adjustment, be sure to
remove any papers from the paper feed
tray, and then confirm that the paper
feed tray has lowered to the bottom.
■ When papers are skipped
Turn the dial counterclockwise.
■ When multiple papers are fed
Turn the dial clockwise.
Set [Paper Feed Adj.] (A
appropriate adjustment values, consult your dealer
or authorized service representative.
Turn the adjustment dial (see above illustrations) for
the stripper plate angle to adjust the angle of the
stripper plate.
74) as necessary. For