When Using The Auto Document Feeder; Printing Of Paper Originals - Riso 9450 User Manual

32
Chapter 2 Basic Operations
BWhen a gauge cover is attached on
the glass platen, place the original
under the gauge cover.
You can lift the gauge cover from
the lower right.
3
Close the platen cover.
BClose the platen cover gently.
Forcefully closing the platen
cover will cause damage to the
glass platen or original scanning
errors.
When using the auto document
feeder
1
Place originals on the auto docu-
ment feeder.
Place the originals with the scanning side fac-
ing up.
BFor the auto document feeder, the
type and the number of originals
to be placed are limited.
(A
BIf the size of an original is smaller
than the size that is allowed on
the auto document feeder, place
the original on the glass platen.
2
Adjust the ADF original guides to
the width of the original.
Gauge cover
14 "Originals")

Printing of Paper Originals

This section describes the procedure to scan and
print paper originals.
1
Check that the power switch of
this machine is on.
Press the [X] side of the power switch.
BWhen an authentication screen
(A 22) is displayed, follow the
instructions on the screen.
2
Check that the master making
basic screen is displayed.
If a screen other than the master making basic
screen is displayed, press the [MASTER MAK-
ING] key (A 21).
3
Place the original.
(A 31 "Placement of Originals")
BThe size of the placed original on
the optional auto document feeder
is displayed next to [Page] in the
master making basic screen. If the
displayed size is different from the
size of the placed original, place the
original again.
4
Check the paper.
(A 28 "Setting up the paper feed tray and the
paper")
BThe size of the placed paper is dis-
played in [Paper] in the master mak-
ing basic screen. If the displayed
size is different from the size of the
placed paper, place the paper again.
BThe position of the paper-feed set-
ting lever
[Paper] in the master making basic
screen.
(A 28) is displayed next to