Error Codes - Ricoh FAX7000L Field Service Manual

5-5. Error Codes

If an error code occurs, retry the communication. If the same problem occurs, try to fix the problem as sug-
gested below.
Three digit error codes can appear with a dash after the first digit; if a report shows code 9-13, see code 913
in this manual.
Error codes 1xxx and three-digit codes will appear on the error report. Other codes will only appear in service
mode operations.
Meaning
Code
1 44 Software error
to
45 System RAM was cleared and reset
by holding down the Stop key for
10 s
46 Temporary power dropout
47 A RAM test was executed (service
function 09)
Suggested Cause/Action
1. Do a RAM test (service function 09, mode 3) to find out if
there is a defective memory chip. Replace the defective board.
2. Replace the MBU or SCU.
There is no problem.
There is no problem.
There is no problem. However, if the MBU RAM was tested,
the hard disk bad sector data must be reprogrammed.
5-48