8-1 ERROR CODES
1.
Protocol Errors
–
G3 transmission –
Code
DIS/NSF/Gl not detected within 35
0-00
seconds after the Start button was
depressed.
0-01
DCN detected
0-02
Remote terminal G3 mode disabled
0-03
Incompatible remote terminal
0-04
CFR or FTT not detected from
remote unit after MODEM training
Meaning
Suggested Cause/Action
1. Check all connections inside the machine.
2. Replace the FCU.
3. Replace the modem.
4. Measure the Rx signal level.
5. Check the received signal on an oscilloscope.
6. Incompatible remote terminal.
1. Check remote terminal for printer failure (jam or empty
roll) or if operator pushed Stop.
Check the remote terminal.
Example:
1850, 1000,800
2. Check the remote terminal.
3. Check the Tx signal level.
4. Check for a line problem.
8-1