Spu Test Menu; Hard Disk Test - Ricoh FAX7000L Field Service Manual

5. Press Function if all service mode operations have been finished.

8. SPU Test Menu

1. Enter the service mode. See page 2-18.
2. When the service mode menu is displayed,
3. The test menu is displayed. Press 6.
4. A list of options is displayed.
Test the motors (the main motor, tx motor, pentagonal mirror motor, master belt drive motor, and lower
paper feed motor are all turned on at the same time) - Press
Test the charge corona (it will switch on after master home position is detected) - Press 1 then Start
Test the charge corona (it will switch on a set interval after you press Start; home position detection is not
tested) - Press 2 then Start
5. Press Stop to end the test.
Either:
6.
• Do another test - go to step 4.
• Press Yes to return to the test menu (press Yes once more to return to the service mode menu).
7. Press Function if all service mode operations have been finished.

9. Hard Disk Test

This is for factory use only.
enter 09 at the ten-key pad.
then Start
0
2-37