Error Codes - Ricoh 5510L Service Manual

ERROR CODES

4.4 ERROR CODES
If an error code occurs, retry the communication. If the same problem occurs, try to
fix the problem as suggested below. Note that error codes 4-00, 01, and 10 only
appear in the error code display and on the service report.
Code Meaning
DIS/NSF not detected within
40 s of Start being pressed
0-00
DCN received unexpectedly
0-01
Incompatible modem at the
0-03
other end
CFR or FTT not received
after modem training
0-04
Unsuccessful after modem
training at 2400 bps
0-05
The other terminal did not
reply to DCS
0-06
Suggested Cause/Action
Check the line connection.
Check the NCU - FCU connectors.
The machine at the other end may be incompatible.
Replace the NCU or FCU.
Check for DIS/NSF with an oscilloscope.
If the rx signal is weak, there may be a bad line.
The other party is out of paper or has a jammed
printer.
The other party pressed Stop during
communication.
The other terminal is incompatible.
Check the line connection.
Check the NCU - FCU connectors.
Try changing the Tx level and/or cable equalizer
settings.
Replace the FCU or NCU.
The other terminal may be faulty; try sending to
another machine.
If the rx signal is weak or defective, there may be a
bad line.
Check the line connection.
Check the NCU - FCU connectors.
Try adjusting the Tx level and/or cable equalizer.
Replace the FCU or NCU.
Check for line problems.
Cross reference
See error code 0-04.
Check the line connection.
Check the FCU - NCU connectors.
Try adjusting the Tx level and/or cable equalizer
settings.
Replace the NCU or FCU.
The other end may be defective or incompatible; try
sending to another machine.
Check for line problems.
Cross reference
See error code 0-04.
4-22
14 June, 2002