Error Codes - Ricoh FAX680MP Service Manual

ERROR CODES

7.8 ERROR CODES
CODE MEANING
0-00 DIS/NSF not received.
0-01 DCN not received.
0-03 The modems cannot
communicate with each
other.
0-04 Response to training
result (CFR or FTT) is
not received.
0-05 Training failure after
falling back to 2400
bps.
0-06 DCS not received.
0-07 Post-message
response not received.
RTN or PIN is received. •
0-08
ACTION
•
Check the line connection.
•
Check the NCU-FCU connection.
•
The machine at the other end may be
incompatible.
•
Replace the NCU or FCU.
•
Check the line connection.
•
Check the NCU-FCU connection.
•
The other terminal has an incompatible
modem.
•
Check the line connection.
•
Check the NCU-FCU connection.
•
Try adjusting the tx level or the cable
equalizer setting.
•
The other terminal may be faulty. Try sending
to another terminal and check the result.
Cross Reference
Tx level - NCU parameter 01 (LEVL)
Tx cable equalizer - BITSW8, bits 0 and 1
•
Check the line connection.
•
Check the NCU-FCU connection.
•
Try adjusting the tx level or the cable
equalizer setting.
Cross Reference
See error code 0-04.
•
Check the line connection.
•
Check the NCU-FCU connection.
•
The other end may be defective or
incompatible.
•
Check the line connection.
•
Check the NCU-FCU connection.
•
The other end may have disconnected the
line due to paper jam, paper end, or memory
overflow.
•
Check for bad line condition.
Check the line connection.
•
Check the NCU-FCU connection.
•
The other end may have disconnected the
line due to paper jam, paper end, or memory
overflow.
•
Try adjusting the tx level or the cable
equalizer setting.
Cross Reference
See error code 0-04.
7-8
31 March, 1997