Dedicated Transmission Parameters - Ricoh FAX7000L Field Service Manual

2-3-17. Dedicated Transmission Parameters

Each destination programmed as a Quick Dial Key or Speed Dial Code can be given dedicated parameters
(such as tx level) that will override the machine's settings when sending to that address. Consult a senior tech-
nician before changing any of these settings.
Each Quick Dial and Speed Dial has a number of switches containing these dedicated parameters. They will be
explained after the procedure.
Procedure
1. Set bit 5 of SCU bit switch 21 to 1. See page 2-19 for how to program bit switches. Then press Function to
return the machine to standby.
2. Press the Function key, enter 51 (Speed Dial), 52 (Quick Dial), 56 (Speed Dial #1) or 57 (Speed Dial #2)
at the keypad.
3. Enter the required Speed Dial Code at the keypad or press the required Quick Dial Key (press No if you
entered the wrong code or pressed the wrong key). Then press Yes three times.
4. The option display should now be visible. Press 8 at the keypad to store dedicated tx parameters.
5. The display now shows the settings for switch no. 1. The highlighted zone shows the current settings of tx
parameter switch number 1. Bit 7 is at the left end of the display, and bit 0 is at the right.
6. To change the setting of a bit, press the key on the ten key pad that corresponds to that bit. For example,
to change bit 3, press 3.
7. If the settings of tx parameter switch number 1 are correct, press the down arrow on the scroll key to
move to the next switch.
2-43