Bit Switches - Function 01 - Ricoh FAX7000L Field Service Manual

2-3-3. Bit Switches - Function 01

1.
Enter the service mode. See page 2-18.
2. When the service mode menu is displayed, enter 01 at the ten-key pad.
3. Either:
• Program SCU bit switches - press 0.
• Program G3 CCU bit switches - press 1.
• Go back to the service mode menu - press Yes.
4. Bit switch 01 is displayed. The default settings are on the top line. The current settings are on the bottom
line, highlighted. Bit 7 is on the left end and bit 0 is on the right.
To increment the bit switch number, press the down arrow on the scroll key. To decrement, press the up
arrow.
To change the setting of a bit switch, press the number of that bit on the ten-key pad. For example, to
change bit 1, press 1.
5. Either:
• Program another bit switch of the same type - go to step 4.
• Program a different type of bit switch or finish programming bit switches - press Yes and go to step 3.
6. Press Function if all service mode operations have been finished.
2-19