Communications Status - Moneris HiSpeed 6200 Operating Manual

2 Features and Procedures
2.1.2.2 On Reports
2.1.3

Communications Status

2.1.3.1 Ethernet Communications Status
4 Moneris HiSpeed 6200 Operating Manual
[Cardholder copy] The Card number will appear masked as 1234567891*********.
[Merchant copy] The Card number will appear masked as 1234***********1111.
For rewards/gift cards:
[Cardholder copy] An Ernex Card number will appear masked as
***************1234 while no Expiry date appears.
[Merchant copy] The Card number will appear masked as 1234***********1111
while the Expiry date will appear fully masked as ****.
An Air Miles Rewards Card number will appear fully as 12345678911.
If a POS Admin card is swiped at the SWIPE ADMIN CARD prompt during a report
transaction, the Card numbers on the printed report will NOT be masked (i.e., the full Card
number is printed). The Card numbers displayed on the screen (e.g., in the
Inquiry) are NOT masked on the terminal display.
If the SWIPE ADMIN CARD prompt is bypassed by pressing the OK key, the Card numbers
are masked on the report and on the terminal display. In addition, the credit card (including
some debit chip cards) Expiry dates are not printed on the report.
As the terminal communicates with the Moneris Host, it displays PROCESSING to indicate
that the transaction is proceeding correctly. Depending on the type of communication,
additional status information is provided
If your terminal is using Ethernet Communications to communicate with the Moneris Host,
the terminal will connect to the Moneris Host each time you begin a transaction (it does not
make any noise when it attempts to connect).
The following symbols appear in the top left corner on the following screens:
TRANSACTIONS, REPORT
To display these icons from the
FUNCTIONS menu.
Icon Description
(Ethernet Connection Available symbol)
appears under normal conditions and indicates that the terminal is
configured to use Ethernet communications and the Ethernet
connection is up.
(Ethernet Connection Not Available symbol)
appears when there is a problem with the Ethernet connection.
An error message
If your terminal is configured to use Ethernet communications AND the Dial Parameters are
configured on your terminal AND your terminal is connected to a dial line:
•
when there is a problem with the Ethernet connection, the terminal will automatically
attempt to use the dial line to communicate with the Moneris Host and the
ETHERNET COMMS ERROR-DIAL USED PRESS OK
FUNCS, ADMIN FUNCS, and
READY screen, press the Admin key to access the ADMIN
may also appear.
Transaction
MAIN MENU,
CONFIG FUNCS.
prompt will appear.