Spray Arm Monitoring/Wash Pressure; Problem Solving Guide - Miele PG 8583 Operating Instructions Manual

Problem solving guide

Spray arm monitoring/wash pressure

Problem
Spray arm monitoring - upper
spray arm: Spray arm blocked
or excessive foaming
or
Spray arm monitoring - lower
spray arm: Spray arm blocked
or excessive foaming
or
Spray arm monitoring - mobile
unit spray arm 1 - : spray arm
blocked or excessive foaming
Spray pressure exceeds
tolerance
Excessive spray pressure
fluctuation
140
Cause and remedy
The rotation speed set has not been reached.
- Items are obstructing the machine or basket spray arms.
Arrange the load so that the spray arms can turn easily

and start the programme again.
- The relevant spray arm is blocked.
Clean the spray arm.

Check whether the filters in the wash cabinet are clean

and correctly inserted.
Start the programme again.

- Wash pressure is too low due to a heavy build-up of foam.
Follow the instructions regarding foam build-up in

"Chemical processes and technology".
Start the Rinsing programme in order to clean the wash

cabinet.
Then reprocess the load again.

The wash pressure differs from the reference value.
Possible causes of fluctuations in the wash pressure
include:
- Defective water connections,
- Open adapters,
- Foam build-up.
Identify and resolve the cause of this.

The programme is not interrupted. Nevertheless, you

must reprocess the load.
A programme was interrupted because of severe
fluctuations in the wash pressure.
Possible causes of fluctuations in the wash pressure
include:
- Defective water connections,
- Open adapters,
- Foam build-up.
Identify and resolve the cause of this.

Reprocess the load again.
