Set Wash Blocktemperature - Miele PG 8583 Operating Instructions Manual

Set
wash block
temperature
The wash block temperature is reached by heating up the wash
water. The temperature must be suited to the requirements of the
task.
At temperatures over 55 °C, protein denaturing occurs which can
cause the soiling to fix.
Infection prevention requirements must be observed as
appropriate.
...
Wash block temperature

Wash block temp.
Without heater
Set
Without heater
–
The wash water is not heated up. The temperature in the wash
cabinet is the result of the temperature of the previous wash block
and the influx of water.
– Set
Setting a wash block temperature.
Select an option using the  and  arrow buttons.

Press OK to save the setting.

Set
When is selected the wash block temperature must then be
entered.
Adjustment is in increments of 1. The possible range is shown in the
bottom line.
Dispensing of chemical agents occurs at a default dispensing
temperature set at the factory. If chemical agents are to be dispensed
in this wash block, the lowest temperature that can be set will be the
dispensing temperature. It is not possible to set a lower value.
Use the arrow buttons  (higher) and  (lower) to set the wash

block temperature.
Press OK to save the setting.

Wash block temp.
60 °C
(30 - 93 °C)
Programme settings
109