Miele PG 8583 Operating Instructions Manual page 133

Problem
Fault 526
Fault 550
Fault 555
Cause and remedy
The supply pressure has dropped below the minimum
value.
- The water pressure is too low due to a heavy build-up of
foam. Spilled rinsing agent may not have been cleaned up
after being added.
Follow the instructions regarding foam build-up in

"Chemical processes and technology".
Start the Rinsing programme in order to clean the wash

cabinet.
- The carriers were loaded incorrectly or overloaded.
Use only mobile units, baskets, modules and inserts

suitable for the particular application.
Arrange hollow or deep-sided wash load items so that

water runs off them freely.
- The water lines are clogged or leaking.
Check and clean the filters in the wash cabinet and spray

arms.
Check the injector bars for possible leaks, e.g.:

– Are all caps and end caps in place?
– Are all connections fitted with nozzles, irrigation sleeves, hose
adapters or other washing attachments?
– Are installed silicone hoses undamaged?
Check the washer's water connectors in the back panel

of the wash cabinet to ensure that they are attached
tightly, and remove any blockages.
- The amount of water may be insufficient for the
application.
Increase the amount of water (see "Programme

settings"). If necessary, consult Miele Service.
The waterproof system has been activated. One of the
water intake hoses might have a leak.
Close the stopcocks.

Contact the Miele Service Department.

Too much water has accumulated in the steam condenser.
Restart the machine. Excess water is pumped out

automatically.
Problem solving guide
133