The action desired at different spray arm rotation speeds is set in
each wash block.
...
Select wash block, e.g.:
Spray arm monitoring
Spray arm monitoring
On -> Stop
On -> Warning
On -> Stop
–
A programme in operation is interrupted if the rotation speed
deviates. The interruption is shown on the display and noted in the
cycle report.
–
On -> Warning
The programme continues to run normally if the rotation speed
deviates. Only a message appears on the display and the deviation
is noted in the cycle report.
Off
–
No message appears and the programme continues to run
normally.
Select an option using the and arrow buttons.
Press OK to save the setting.
Programme settings
Main wash 1
105