Spray Arm Monitoring/Wash Pressure; Frequently Asked Questions - Miele PG 8583 Operating Instructions Manual

Spray arm monitoring/wash pressure

Problem
Spray arm monitoring - Upper
spray arm: Spray arm blocked
or excessive foaming
or
Spray arm monitoring - Lower
spray arm: Spray arm blocked
or excessive foaming
or
Spray arm monitoring - mobile
unit spray arm 1 - : spray arm
blocked or excessive foaming
Spray pressure exceeds
tolerance
Spray pressure fluctuating too
much
Possible cause and solution
The rotation speed set has not been reached.
- items are obstructing the machine or basket spray arms.
Arrange the load so that the spray arms can turn easily

and start the program again.
- the relevant spray arm is blocked.
Clean the spray arm.

Check whether the filters in the wash chamber are clean

and correctly inserted.
Start the program again.

- wash pressure is too low due to a heavy build-up of foam.
Follow the instructions regarding foam build-up in

"Chemical processes and technology."
Start the Rinse program to clean the wash chamber.

After that, reprocess the load.

The wash pressure differs from the reference value.
Possible causes of fluctuations in the wash pressure
include:
- defective water connections,
- open adapters,
- foam build-up.
Identify and resolve the cause of this.

The program is not interrupted. Nevertheless, you must

reprocess the load.
A program was interrupted because of severe fluctuations
in the wash pressure.
Possible causes of fluctuations in the wash pressure
include:
- defective water connections,
- open adapters,
- foam build-up.
Identify and resolve the cause of this.

Reprocess the load again.


Frequently asked questions

139