Table of Contents
Advertisement
between dialing valid digits before dropping the call and returning the user
to error tone.
Isdn int dgt tm (1-15 SEC)
!
dialing valid digits and the end of the dialing string on an ISDN call.
!
Kmmc lock out tm (10-255 SEC)
between
programming
automatically returns the system to secure programming status.
!
Lcr advance time (1-255 SEC)
time before selecting the next allowable route when a station is allowed to
route advance.
!
Lcr inter digit (1-255 SEC)
between dialing valid digits before dropping the call and returning the user
to error tone.
!
Mcl delay time (1-8 SEC)
system should start transmitting Authorisation code after sending MCL Access
code.
!
Ms led on time (0-10 SEC)
Manual Signalling key will remain on after use.
!
Off hook ring ind (1-255 SEC)
ring bursts to a user who has a camped-on call.
!
hook select (1-255 SEC)
Off
before placing an internal/external call as programmed in MMCs 306 and 307.
!
Ohva answer time (1-255 SEC)
an OHVA call before automatic rejection.
Page tone time (100-2500 MSEC) : This timer controls the duration of tone burst
!
heard over the page prior to the page announcement.
Park recall time (0-255 SEC)
!
before recalling to the call park originator.
!
Power down time (100-2500 MSEC)
to the ROM pack to begin shutdown status.
!
Recall disconnect (1-255 MIN)
will ring before being disconnected.
!
Recall wait time (0-255 SEC)
transfer) continues to recall at your station before it recalls to the
operator.
!
Sys hold recall (0-255 SEC)
can be left on hold before recalling the holding station. This is a system-
wide timer. Setting this timer to 000 means that no recalling will take
place.
!
Transfer recall (0-255 SEC)
transferred calls ring before recalling. This is a system-wide timer.
Tech Passcode
Tech Passcode
Tech Passcode
Tech Passcode
On the Tech Passcode screen, you can set or reset the passcode needed for
technical programming.
Enter a four-digit passcode using the numbers 0 ~ 9 into the Technical Passcode
parameter. Click the Set button.
Tenant On Off
Tenant On
Tenant On
Tenant On
On the Tenant On Off screen, you can select whether to use system functions. Tick
on the parameters for the functions you want.
To use a feature, tick the relevant parameter(s) and click the Set button.
LCR Enable : Select whether to use LCR function or not.
!
CID Insert Code : Save country code in CID.
!
Transfer MOH : Send the tones for held calls instead of paging tones when you
!
forward calls.
DSP SSPD NAME : Display names instead of numbers in DSP SSPD mode.
!
DID Busy Route : Transfer the calls to relay station when DID station is busy.
!
actions
while
Off
Off
Off
DCS-VIP User Guide
: This timer controls the grace period between
: This timer controls the grace period
in
a
programming
: This timer controls the period of
: This timer controls the grace period
: This timer controls the time when the
: This timer controls the duration a
: This timer controls the time between
: This timer controls the grace period
: This timer controls the duration of
: This timer controls the time a call is parked
: This timer monitors the power
: This is the time an attendant recall
: This is the time any recall (hold or
: This timer determines the time calls
:
This
timer
56
session.
The
timer
determines
the
time
Advertisement
Table of Contents
