Table of Contents
Advertisement
Chapter 4 Basic Configuration & Setup (Setup
Wizard)
The first thing to do after installing the DCS-VIP is to boot the system and to
configure the ISP (Internet Service Provider) or a remote node information. The
DCS-VIP is able to set up the system configuration using the web browser.
This chapter explains how to set up the system for connecting to the Internet or a
remote node, in the following order.
Configuration Checklist
!
System Setup Procedure
!
Turning on the System
!
Connecting to the Web Management screen
!
Configuring the Initial Environment (Setup Wizard)
!
Configuration Checklist
To connect to the Internet through the ISP, first apply for the service at the ISP
!
and be sure to remember the ISP connecting telephone number, the Login Name
and the Password.
To connect to the remote network of the head office or the branch office, first
!
have your router's IP address and subnet mask allocated by the network
administrator. Write down the network connecting telephone number, the
router's IP address and the subnet mask information.
Check that the Ethernet 10/100Base-T network is properly connected to the
!
network and ISDN line on the rear port of the DCS-VIP.
Check that the power cord is properly connected to the wall socket and the DCS-
!
VIP's power input connector.
Check that the network adapter's driver is installed in the PC connected to the
!
DCS-VIP through the Ethernet port.
System Setup Procedure
The following is the configuration necessary for connecting to the Internet or the
remote router using the DCS-VIP, and for using the Keyphone and VoIP features.
Turning on the system
DCS-VIP User Guide
23
Advertisement
Table of Contents
