Samsung DCS-VIP User Manual page 36

Configuring the Router Function
In the Router Setup Wizard, you can configure the LAN and WAN environment
necessary for connecting to the Internet or a remote node, using the DCS-VIP. Click
the WIZARD SETUP
Router Wizard Setup - Setup 1 Router Wizard Setup - Setup 1
Router Wizard Setup - Setup 1 Router Wizard Setup - Setup 1
On this screen, you can set up the counterpart that you are using the DCS-VIP to
connect to and the functions of DHCP and MLPPP.
Set the following parameter values and click the Next button.
Connection To : Select what you want to connect DCS-VIP to (ISP, or Remote
!
Router)
− ISP Connection : Connect to ISP.
− Remote Router Connection : Connect to remote routers such as branches and
headquarters.
DHCP Server : Choose whether to use DCS-VIP system as DHCP server.
!
− Enable : Select to allocate IP in Ethernet PC connected to DCS-VIP.
sure you select "Enable" for ISP connection.
− Disable : Select not to use DHCP function. If you select "Disable", the
network administrator should set up the network information, including IP
address in Ethernet PC.
ML-PPP (Multilink PPP) : MLPPP is the protocol that combines more than two
!
ISDN B channels into one PPP (128Kbps). Select "Enable" to use MLPPP
function.
Nuber of Channels : Select the bandwidth(64K/128K) for the ISDN line. If you
!
select 128K, then you are using 2 different B channels at the same time. Thus,
phone charges will be doubled.
Router Wizard Setup - Setup 2 Router Wizard Setup - Setup 2
Router Wizard Setup - Setup 2 Router Wizard Setup - Setup 2
On the Router Wizard Setup - Setup 2 screen, you can enter the information about
the ISP or the remote node to connect to.
For ISP connection
ROUTER SETUP.
36
DCS-VIP User Guide
Make