Table of Contents
Advertisement
Programming Using MMCs
This section explains how to program using the MMCs. You should read
the
instructions
program.
First, decide what changes are required to the system, and therefore
which MMCs you need to use. Then, "ENABLE" the keyphone (as described
above) and follow the procedure for your selected program(s).
Important
If you are installing the system for the first time, you must run MMC
812 (Set Country) before any other programming is done. This selects
the correct system software version.
100
100
100
100
STATION LOCK
STATION LOCK
STATION LOCK
STATION LOCK
Allows the system administrator or technician to lock or unlock an
individual station or all stations simultaneously. The three options
are as follows:
0
UNLOCKED
1
LOCKED OUTGOING
system. It can
2
LOCKED ALL CALLS
When in this
DEFAULT DATA
ALL STATIONS UNLOCKED
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
ANS/RLS
ACTION
1.
Press TRSF 100
Display shows
[201] STN LOCK
UNLOCKED
2.
Dial station number (e.g., 205)
OR
Use UP and DOWN to select station
And use RIGHT soft key to move cursor
OR
Press ANS/RLS to select all stations.
[205] STN LOCK
UNLOCKED
3.
Enter 0 to unlock or 1 or 2 to lock (e.g., 1)
OR
Use UP and DOWN key to make
selection and press RIGHT soft key
to return to step 2
[ALL] STN LOCK
?
4.
Press TRSF to save and exit
for
each
program
Unlocks a locked station.
The
keyset
however make and receive intercom calls and
receive
incoming C.O calls. When in this mode the HOLD
key of the keyset will flash slow RED.
The keyset cannot make or receive any calls.
mode the HOLD key of the keyset will light
steady RED.
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to select ALL
DISPLAY
82
DCS-VIP User Guide
carefully
before
cannot
make
calls
starting
the
outside
the
Advertisement
Table of Contents
