Table of Contents
Advertisement
Router Wizard Setup - Confirm Page
Router Wizard Setup - Confirm Page
Router Wizard Setup - Confirm Page
Router Wizard Setup - Confirm Page
Initial set up for the user environment of the LAN and WAN is now completed.
Confirm the values on the Wizard Setup - Confirm Page screen. If you have
anything to correct, click on Prev button to go back to the previous stage. If not,
click on the Exit button.
Note
NAT (Network Address Translation) will enable more than two users to
communicate simultaneously using one account
service.
For ISP connection, the NAT function will be automatically enabled.
For Remote Router connection the NAT function will be automatically
disabled.
Now that initial set up for the DCS-VIP router module is completed, you will be able
to connect to the Internet and to the remote router through the ISP.
Configuring the VoIP Function
The VoIP Setup Wizard can set up the necessary information about how to use the
Internet phone
SETUP
KEYPHONE SETUP.
VoIP IP Address
VoIP IP Address
VoIP IP Address
VoIP IP Address
On the VoIP IP Address screen, you can set up the VoIP gateways' IP address and
the subnet mask.
Set the following parameter values and click the Next button.
VoIP IP Address : Enter the VoIP gateway IP address.
!
Subnet Mask : Enter the subnet mask of VoIP gateway.
!
Gateway : Enter the gateway IP address.
!
charging the inexpensive communication
38
DCS-VIP User Guide
if you use ISDN PPP
rate. Click the WIZARD
Advertisement
Table of Contents
