Table of Contents
Advertisement
the ISP or remote network administrator.
PPP Incoming Security Setup
Remote router name and password can be set up for remote router connection and
ISP LAN service. Remote router name and password are set up for unauthorized
users who want to connect to the user's DCS-VIP router in remote router or ISP.
Set the following parameter values and click the Set button.
Remote Router Name :
!
router from the other network, enter the necessary login name.
Remote Router Password :
!
router from the other network, enter the necessary password.
PPP LCP Setup
You can specify the various options necessary for PPP link setting on the PPP LCP
Setup screen.
Channel : This is the connecting factor between WAN and the routing table.
!
This will connect the address book that the user chose in the PPP Setup menu
and the IP routing table. Select the address book that you want to connect IP
routing table to.
Circuit Index : If you select X.25 for WAN protocol, enter the virtual circuit
!
number as X.25. If you select PPP for WAN protocol, enter '0'.
Authentication Status of Router :
!
the destination network by entering Incoming User Name and Incoming User
Password set in PPP Incoming Security Setup menu
'ENABLE'.
PPP Idle Timer :
!
set in this parameter, the PPP link is deallocated automatically. The timer value
range is 3~3600(seconds).
Remote IP Address Negotiation : Select whether to use the IP address that
!
you have given for ISP connection. Select "ENABLE" for ISP connection and
select "DISABLE" for remote router.
PPP Link Operational Status : This displays the operational status of the
!
PPP link. This parameter is read-only.
After finishing setting up all the parameters above, click on the SET button. If you
want to make a new PPP LCP information for another channel, click on the NEXT
button to enter the new PPP LCP information. Then, click the SET button.
Manual Call Setup
On the Manual Call Setup screen, after completing the router module
configuration setting for DCS-VIP system, you can connect/disconnect physical
channel to connect to the ISP or remote router.
Channel Selection : Select the address book that you need to connect/
!
disconnect the physical channel for ISP or remote router connection.
To connect the physical channel, click the CONNECT button.
To disconnect the physical channel connection, click the DISCONNECT button.
ML PPP Setup
MLPPP is the protocol that combines more than two ISDN B channels into one PPP.
Therefore, MLPPP enables you to use 128Kbps in one ISDN B channel, transmitting
data at a faster speed. On the ML PPP Setup screen, set up the following
When you want to connect to the user's DCS-VIP
When you want to connect to user's DCS-VIP
If the user network can be connected to
If no packet is transmitted on the PPP link during the time
66
DCS-VIP User Guide
correctly, set this item to
Advertisement
Table of Contents
