Sartorius Cubis Series User Manual page 59

Example Automatic Printout to Peripheral Port, Second Display Operating Mode
At a preset interval, automatic printouts should be sent to the connected
y
peripheral device as a second display.
Printout interface: Com A (peripheral port)
Protocol: Remote display (toggling to port configuration possible)
SBI output: Automatic printout
Criterion: Without stability, at stability, or after weight change
Format: 22 characters (for applications)
Interval for automatic printing: Display updates (1, 2, 5, 10 to100) or every 0.1, 0.2,
0.5 to 10 seconds
Example Printout to Peripheral Port Only By Pressing the PRINT P Key; Printer
Operating Mode
After pressing the Print key, the measured value should be printed by the
y
connected peripheral device.
Printout interface: Com A (peripheral port)
Protocol: Print (toggling to port configuration possible)
Standard printout: Standard 1 (measured value only), Standard 2 (measured value
and date/time), Standard 3 (measured value with date/time and weight block)
GLP printing: On or off
Print event: Press the PRINT key
Elements for print event PRINT: Measured value PRINT.MEASURE
Tare after printing: On or off
Printout Parameter Settings
Standard Printout
You can select which data should be printed out as default.
(measured value only)
Standard 1
(measured value and date/time)
Standard 2
(measured value with date/time and weight block)
Standard 3
is only selectable if the default settings have been modified
User input
by the user.
GLP Printing
You can select if and when the printout should be GLP-compliant.
Off, no GLP printout
For calibration/adjustment only
Always on
is only selectable as long as none of the three options apply, i.e.,
User input
if only a GLP header but not a GLP footer has been configured.
Task Management (TASK)
Cubis MSU User Manual 59