Sartorius Cubis Series User Manual page 49

Select the connected hardware device or control function.
t
During checkweighing, the control outputs have no function when set to:
h
– Foot switch YPE01RC
– Control inputs
Configure the settings for the control inputs and outputs.
t
Options: Off, no function / TARE key / PRINT key / Cal./Adj. key /
Zeroing / Taring
To save the settings, select
t
Alibi Memory Configuration
Here you can switch on the alibi memory, delete the recorded data, and set
the interval for automatic deletion.
Use the cursor softkeys to navigate through the
t
submenu to
Alibi memory configuration
Alibi Memory On/Off
Select whether you want to have the alibi memory switched on or off.
t
Automatic Deletion of Older Data
Define whether the data stored in the alibi memory should be deleted auto -
t
matically at regular intervals after a pre-specified time.
If data should be regularly deleted, enter the desired interval (deletion cycle)
t
in days.
Reset and Initialize Alibi Memory
You can delete all data from the alibi memory immediately. The settings
for the alibi memory (on/off, deletion cycle) will remain stored.
To delete data in the alibi memory, confirm deletion when prompted.
t
Update Software
Cubis software is updated at regular intervals. A detailed description of how
to perform a software update on your balance can be found in Section Updating
the Software.
System Settings (Menu)
.
Save
Device parameters
.
Cubis MSU User Manual 49