Sartorius Cubis Series User Manual page 106

Parts Counting
106 Cubis MSU User Manual
Define the accuracy to be used for the weight value.
t
*Normal resolution
10-fold (+ 1 dec. place):
100-fold (+2 dec. places):
Only with calculation of reference piece weight:
Define whether or not the piece weight should be updated when counting.
t
Optimization off
*By pressing key, after prompt
Automatic updating
An overview of all settings is displayed.
y
Check all settings and change as required.
t
A message asks whether you would like to add another application.
y
If required, select additional applications to be combined.
t
Now you will be prompted to configure the weighing and printing functions.
y
Check all settings and change as required.
t
Enter a short name and a description for the new task.
t
To save the new task, select
t
Executing a Task:
Parts Counting with Reference Piece Weight Calculation
If you haven't already done so, go to Application Management.
D
t
y The task selection is displayed.
Select the desired task.
t
or
If the desired task is already marked, select
t
The last used reference piece quantity
y
If you are working with a variable reference piece quantity, you must enter
t
or change this now.
Place this exact amount (nRef) of the objects to be counted on the
t
weighing pan.
: As displayed
With one decimal place more than on the display
With two decimal places more than on the display
.
Save
Start
is displayed.
nRef
.