Sartorius Cubis Series User Manual page 11

3
2
1
Assembly
Installing the Analytical Draft Shield; Balance Assembly
(Draft Shield Identification: DA, DI, and DU)
Fit parts onto the balance as shown in the picture.
t
1. Shield plate
2. Pan support (not for MSx225.../MSx125... models)
3. Weighing pan
Slide the upper draft shield panel into the guide rails from the rear.
t
Slide the side draft shield panels into the guide rails from the rear.
t
Make sure the panels are fully inserted into the upper and lower
guide rails.
Slide the panels in until they snap into place.
t
1. Right draft shield panel
2. Left draft shield panel
y This completes the balance assembly.
Getting Started
Cubis MSU User Manual 11