Removing The Door Switch Assembly Front Panel And Bellows - Whirlpool WFW94HEX Technical Education

REMOVING THE DOOR SWITCH ASSEMBLY FRONT PANEL AND BELLOWS

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover and the console
("REMOVING THE DISPENSER DRAWER, TOP AND
CONSOLE ASSEMBLY" for the procedures).
4. Open the washer door.
Tension Spring
5. Using a small screwdriver or a pair of long-
nosed pliers, pull the tension spring on the
retaining wire out from around the front of
the bellows, and remove the wire.
6. To remove the door switch assembly:
a) Pull the bellows off the lip of the front panel
beside the door switch assembly just enough
to access the switch assembly.
Bellows
b) Remove the two T-20 Torx screws from
the door switch assembly.
c) Pull the door switch assembly out and
turn it over so that you can access the
connectors.
d) Unlock the tabs and disconnect the wire
connectors from the door switch termi-
nals, then remove the assembly.
Connectors
4-12
Water Inlet
Door Switch
Door Switch Screws