Removing The Door Lock Assembly - Whirlpool WFC8090GX Service Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Door Lock Assembly
1. Unplug washer/dryer or disconnect power.
2. Turn off water supply to washer/dryer.
3. Disconnect cold inlet water hose and remove the drain
hose from the standpipe or laundry tub.
4. Perform the procedures on page 4-2 "Removing the Door
Assembly" prior to performing the following steps.
5. Perform the procedures on page 4-3, "Removing the Top
Panel" prior to performing the following steps.
6. Perform the procedures on page 4-6 "Removing the Front
Panel Assembly" prior to performing the following steps.
7. Remove the spring clamp securing the outer bellows to
the front bulkhead. Loosen and pull away the bellows
from the opening in the bulkhead.

Removing the Door Lock Assembly

8. Remove the manual door unlock strap from the lock
assembly (see Figure 1).
9. Using a pair of needle nose pliers, depress tabs on clip and
push through the bulkhead (see Figure 1).
10. Remove the two (2) Phillips screws securing the lock
assembly to the bulkhead (see Figure 1).
Manual Unlock
Lock Harness
wire-tie clip
11. Reach in between bellows and front bulkhead and pull the
door lock assembly out through the opening. (It may be
necessary to disconnect the door lock harness.)
12. Reverse procedure to reinstall the door lock assembly.
Whirlpool Smart All-In-One Washer & Dryer
COMPONENT ACCESS
Door Lock
Assembly
Remove 2
Screws
Pull Strap
Figure 1
4-15
n