Removing The Line Filter & Power Supply Cord - Whirlpool Duet Sport WFW8300SW Instruction Manual

REMOVING THE LINE FILTER & POWER SUPPLY CORD
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover from the washer
(see page 4-2 for the procedure).
4. To remove the line filter:
a) Remove the T-20 Torx/hex-head screw
from the line filter.
b) Position the line filter so that the four
tabs are aligned with the chassis slots
and remove the filter from the washer.
Screw
Line Filter
4 Tabs
Line Filter
c) Disconnect the three wire connectors
from the line filter. NOTE: Press and re-
lease the locking arm on the 2-wire con-
nector to disconnect it from the filter.
5. To remove the power supply cord:
a) Remove the screw from the green
ground wire.
b) Pull the connectors with the white and
black wires from the line filter termi-
nals.
Ground Screw
Black Wire
White Wire
4-8
Line Filter Wire
Connectors