Removing The Line Filter & Power Supply Cord - Whirlpool WFW94HEX Technical Education

REMOVING THE LINE FILTER & POWER SUPPLY CORD
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover from the washer
("REMOVING THE DISPENSER DRAWER, TOP AND
CONSOLE ASSEMBLY" for the procedure).
4. To remove the line filter:
a) Remove 2 T-20 Torx/hex-head screws
from the line filter.
b) Position the line filter so that the four
tabs are aligned with the chassis slots and
remove the filter from the washer.
Line Filter
c) Disconnect the three wire connectors from
the line filter. NOTE: Press and release the
locking tabs on the 2-wire connector to
disconnect it from the filter.
Tabs
Green Ground Wire
5. To remove the power supply cord:
a) Remove the screw from the green ground
wire.
b) Pull the connectors with the white and
black wires from the line filter terminals.
c) Pull the washer away from the wall far
enough to access the power supply cord
on the rear panel.
d) Use a pair of pliers and turn the strain re-
lief on the power supply cord 90° in either
direction. Align the strain relief key with
the slot in the rear panel, and remove the
cord from the washer.
Power Supply
Cord Strain Relief
4-8
Slots
Ground Screw