M/A-Com M7100IP Series Installation Manual page 60

Field Programming Procedure for Remote/Remote Mount Dual
Radio Configuration
The Radio and Control Units must be programmed in a sequential procedure
in order to provide each Control Unit with the proper identification code.
Step 1 Configure the M7100
setup as shown in Figure 34, Step 1 with the Slave Radio
disconnected. Program the Master Radio with the control
configurations
Procedure with ProGrammer – Dual Radio Units and adjust
as necessary for the desired application.
Step 2 Now configure the Slave Radio with ProGrammer as shown
in Figure 34, Step 2. The Master Radio should now be
disconnected, with the Slave Radio connected as indicated.
Program the Slave Radio with the configuration per the Pre-
Installation Programming Procedure with ProGrammer –
Dual Radio Units and adjust as necessary for the desired
application.
60
IP
Master Radio per the ProGrammer
per the Pre-Installation Programming