Pre-Installation Programming Procedure With Programmer - Remote Mount - M/A-Com M7100IP Series Installation Manual

IP
Figure 22 – M7100 Dual Control Unit PC Programming Configuration
PRE-INSTALLATION PROGRAMMING PROCEDURE
WITH PROGRAMMER - REMOTE MOUNT
The Radio and Control Units must be programmed in a sequential procedure,
in order to provide each Control Unit with the proper identification code.
1. Configure the M7100
Assembly, as shown in Figure 23, Step 1. Program the radio with the
following control configurations:
Network Options
Dual Control
Audio Mode
Switching Mode
Siren Light Controller
Siren Light Connection
Speaker
Multiple Radio
Program Radio Setup
Mobile Options
IP
M7100 Options
Write System Keypad File
40
IP
Remote Mount Radio with ProGrammer
Enable
Active
Independent
Unit A
Unit A
Disable
Disable
Push Button
Enable (System control unit)