Programming With Pc Programmer - Dual Radio Units - M/A-Com M7100IP Series Installation Manual

Figure 32 - M7100
PROGRAMMING WITH PC PROGRAMMER – DUAL
RADIO UNITS
Once installed, the M7100
cable assemblies CA101288V2, V4, and V10. Please Note: Keyloading and
Data functions are also available through the P5 connector on these cables. In
addition, extended options are supported on ONE radio unit only. Follow the
applicable instructions for extended option programming.
Field Programming Procedure for Front/Remote Mount Dual
Radio Configuration
The Radio and Control Units must be programmed in a sequential procedure
in order to provide each Control Unit with the proper identification code.
Step 1 Configure the M7100
setup shown in Figure 33, Step 1, with the Slave Radio
disconnected. Program the Master Radio with the control
configurations
Procedure with ProGrammer – Dual Radio Units and adjust
as necessary for the desired application.
Step 2 Now configure the Slave Radio with ProGrammer as shown
in Figure 33, Step 2. The Slave Radio should now be
disconnected with the Slave Radio connected as shown.
Program the Slave Radio with the configuration per the Pre-
58
IP
Dual Radio Remote Mount/Remote Mount
Installation Configuration
IP
can be programmed through connector P5 on
IP
Master Radio per the ProGrammer
per the Pre-Installation Programming