Speaker - M/A-Com M7100IP Series Installation Manual

2. Position the Pigtail Bracket with the connector facing away from the side
and towards the front of the radio. The Pigtail Bracket can be installed on
either side of the radio.
3. Remove the first two radio mounting bracket screws and lockwashers
located closest to the front of the radio. Retain this hardware for Step 5.
4. Align the bracket hole at the smaller end of the Pigtail Bracket with the
middle hole on the radio bracket and the corresponding hole in the radio
chassis. Insert an M4 x 10mm hex head screw and lockwasher and
loosely tighten.
5. The other slot in the Pigtail Bracket will enable flexible positioning of the
pigtail. Position the bracket, insert the remaining M4 x 10mm hex head
screw and lockwasher. Tighten both of the hex head screws to maintain
the desired Pigtail position. See Figure 17.
Figure 17 – Pigtail Bracket Mounted on Radio

SPEAKER

The speaker kit includes the speaker, mounting bracket and connecting cable.
Mount the speaker so it is directed to the operator but does not present a
hazard in the event of an accident. The speaker may be mounted on the lower
edge of the instrument panel, the firewall or above the windshield in some
trucks.
31